Installation Guide

ENGLISH

DRAIN BODY INSTALLATION

7 SECURING FAUCET

From underneath sink, secure Faucet Body (7A) by placing Metal Washer (7B) and

threading Long Nut (

Hex.) (7C) onto Mounting Post (7D). Make sure that the bumps

on Metal Washer (7B) are facing up. Firmly hand tighten Long Nut (7C). Secure Long

Nut (7C) not to exceed a

turn.

Caution: Do not over tighten!

8 WATER SUPPLY LINES

Gently separate hot and cold Supply Tubes (8A), approximately three inches apart.

Connect water Supply Lines (8C) to Faucet Inlets (8B). Hot water supply line goes to hot

inlet ﬁtting indicated by red tag (8D). (Supply lines not included). Follow manufacturer’s

instructions when installing supply lines.

Hold the Faucet Inlets (8B) steady using an adjustable wrench while tightening Supply

Lines (8C). Do not twist Supply Tubes (8A)!

9 POP-UP ROD CONNECTION

Insert Lift Rod (9A) into hole at the back of Faucet Body (9B).

10 POP-UP INSTALLATION

Install and adjust Pop-Up (10A) using separate instructions supplied with the Pop-Up

assembly.

11 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink.

HOT

COLD

10A