Installation Sheet

ENGLISH

7 10

FAUCET FUNCTIONS

MAINTENANCE & CARE

7 WATER SUPPLY CONNECTIONS

Connect water Supply Lines (7A) to Faucet Inlets (7B). Hot water supply lines go into

left inlet. Cold water supply lines go into right inlet. (Supply lines are not included).

Please follow manufacturer’s instructions when installing supply lines.

8 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink.

9 FAUCET FUNCTIONS

COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,

open-counterclockwise. The Spout (9A) can be rotated around the Faucet Body in

any direction.

Note: Flush faucet before turning on valve (see step 11).

10 SIDE SPRAY OPERATION

The Side Spray (10A) can be pulled forward to spray water in any direction. To activate

the Side Spray, press the Toggle Button (10B) located on the back of the Side Spray (10A).

11 FLUSHING & AERATOR CLEANING

After installation is complete, remove Aerator Housing (11A). Turn Valves (11B) on

and allow both hot and cold water to run for at least one minute each. While water is

running, check for leaks. To clean the aerator, disassemble Aerator Housing (11A) by

separating the Aerator Shell (11C), Basket (11D) and Washer (11E). Once parts have

been cleaned, reassemble by reversing steps.

10A

10B

HOT

COLD

HOT COLD

OPEN OPEN

11B

11A

11E

11D

11C