Installation Guide

ENGLISH

DRAIN BODY INSTALLATION

10 HOSE CONNECTION

From underneath sink, push Center Connector (10A) onto receiving Tube (10B), until

unable to push any further. Pull down on Center Connector (10A). If the housing and

the Inner Collet (10C) separate slightly but do not pull off receiving Tube (10B), the

connection is secure.

To remove, push up on Center Connector (10A) holding plastic Collet (10C) in place,

pull down on Center Connector (10A) until Tube (10B) is free.

Slide the End Connectors (10D) with arrow (10E) pointing up onto the Valve Bodies

(10F). Push the End Connectors (10D) all the way up until completely seated. Be

careful not to damage O-Rings (10G).

11 WATER SUPPLY CONNECTIONS

First, thread Inlet Connectors (11A) into Water Supply Lines (11B). Then, insert Inlet

Connectors (11A) into Valve Bodies (11C). Hot water supply lines go into left inlet.

Cold water supply lines go into right inlet. (Supply lines not included). Please follow

manufacturer’s instructions when installing supply lines. Next, insert Clips (11D) into

Valve Body Holes (11E), to secure unit.

WARNING: Do not twist Inlet Connectors (11A) once installed!

12 POP-UP INSTALLATION

Install and adjust Pop-Up (12A) using separate instructions supplied with the Pop-Up

assembly.

HOT

COLD

12A

10B

10A

10D

10F

10G

10E

10D

10A

10C

10B

10A

10C

11A

11D

11E

11D

11A

11B

11C