Installation Guide

ENGLISH

FAUCET FUNCTIONS

MAINTENANCE & CARE

8 SECURING FAUCET

Align Faucet (8A) to sink surface. From underneath sink, secure faucet by using Wing

Nuts (8B). Hand tighten.

9 WATER SUPPLY CONNECTIONS

Connect water Supply Lines (9A) to Faucet Inlets (9B). Hot water supply lines go into

left inlet. Cold water supply lines go into right inlet. (Supply lines not included). Please

follow manufacturer’s instructions when installing supply lines.

10 UNIT START UP

Turn on water supply inlet valves and check for leaks.

11 FAUCET FUNCTION

COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,

open-counterclockwise. The Spout (11A) can be rotated around the Faucet Body in

any direction.

13 FLUSHING & AERATOR CLEANING

After installation is complete, remove Aerator Housing (13A). Turn Valves (13B) on

and allow both hot and cold water to run for at least one minute each. While water is

running, check for leaks. To clean the aerator, disassemble Aerator Housing (14A) by

separating the Aerator Head (13C), Basket (13D) and Washer (13E). Once parts have

been cleaned, reassemble by reversing steps.

11A

HOT COLD

CLOSED

OPEN

CLOSED

OPEN

HOT

COLD

12 SIDE SPRAY OPERATION

The Side Spray (12A) can be pulled forward to spray water in any direction. To activate

the Side Spray, press the Toggle Button (12B) located on the back of the Side Spray (12A).

12A

12B

13A

13B

13E

13D

13C