Instructions / Assembly

ENGLISH

7 SECURING FAUCET

From underneath sink, secure Faucet Body (7A) by placing Metal Washer (7B) and

threading Long Nut (

Hex.) (7C) onto Mounting Post (7D). Make sure that the bumps

on Metal Washer (7B) are facing up. Tighten loosely, make sure Handle (7E) swings

equally in both directions. Firmly hand tighten Long Nut (7C). Make sure Lift Rod (7F)

moves freely. Secure Long Nut (7C) not to exceed a

turn.

Caution: Do not over tighten!

8 WATER SUPPLY CONNECTIONS

Gently separate hot and cold Supply Tubes (8A), approximately three inches apart.

Connect water Supply Lines (8C) to Faucet Inlets (8B). Hot water supply line goes to hot

inlet tting indicated by red tag (8D). (Supply lines not included). Follow manufacturer ’s

instructions when installing supply lines. Do not twist Supply Tubes (8A)

9 POP-UP INSTALLATION

Install and adjust Pop-Up (9A) using separate instructions supplied with the Pop-Up

assembly.

10 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink.

11 VALVE FUNCTION

By lifting the Lever Handle (11A) up, the valve will be activated allowing water to ow.

The water ow will increase by continuing to lift up the Lever Handle (11A). By rotating

the Lever Handle counter-clockwise, the water temperature will decrease to cold ow

only. By rotating the Lever Handle clockwise, the water temperature will increased to

hot ow only.

Note: Flush faucet before turning on valve (see step 12)

DRAIN BODY INSTALLATION

FAUCET FUNCTION

11A

HOT COLD

OPEN

HOT

COLD