Installation Guide
ENGLISH
ENGLISH
14
16
15
17
14 FAUCET PREPARATION
From underneath faucet, remove Nut (14A) from Mounting Post (14B). Remove Putty
Plate (14C) and Deck Plate (14D) from Faucet Body (14F). Assemble Mounting Ring
(14E) and Putty Ring (14G) to Faucet Body (14F). Secure by placing and threading Nut
(14A) onto Mounting Post (14B).
15 FAUCET INSTALLATION
Following manufacturer’s recommendations on use, apply plumber’s putty into putty
groove in Putty Ring (15A). Insert the faucet Supply Tubes (15B) through the center
hole of the sink.
16 SECURING FAUCET TO DECK
Remove any excess putty from around the outside edge of Mounting Ring (16A). From
underneath sink, secure the faucet by placing the Metal Washer (16B) and the Long
Nut (
7
/
16
Hex.) (16C) onto the Mounting Post (16D). Make sure that the bumps on the
Metal Washer (16B) are facing up. Tighten until the faucet is rmly connected to the
sink. Do not over tighten!
17 WATER SUPPLY LINES
Gently separate hot and cold Supply Tubes (17A), approximately three inches apart.
Connect water Supply Lines (17C) to Faucet Inlets (17B). Hot water supply line goes to hot
inlet tting indicated by red tag (17D). (Supply lines not included). Follow manufacturer’s
instructions when installing supply lines. Do not twist Supply Tubes (17A)!
17 WATER SUPPLY CONNECTIONS
A.
Thread Inlet Connectors (17A) into Water Supply Lines (17B).
B. Remove Protective Cap (17F). Gently separate hot and cold Faucet Inlets (17C),
approximately 1 in. (26 mm) apar t. Connect Water Supply Lines (17B) onto Faucet Inlets
(10C). Hot water supply line goes to hot inlet tting indicated by red tag.
C. Insert Clip (17D) into Inlet Connector Holes (17E) to secure water supply lines, as
shown.
Water Supply Lines are not included. Please consult
manufacturer and/or its instructions for the correct
method of installation of supply lines and ttings.
CAUTION: Incorrect application of supply lines and ttings may
result in the failure or leak of the supply lines and ttings.
5
16A
16D
16B
16C
14A
14B
14C
14D
14F
14F
14A
14B
14E
14G
15A
15B
1" Max.
(26 mm)
A
B
C
17A
17B
17C
17C
17C
17C
17A
17F
17B
HOT COLD
17D
17E
17B
17D
17B
17A