Installation Guide

ENGLISH

DRAIN BODY INSTALLATION

8 WATER SUPPLY CONNECTIONS

Gently separate hot and cold Supply Tubes (8A), approximately three inches apart.

Connect water Supply Lines (8B) to Faucet Inlets (8C). Hot water supply line goes to hot

inlet tting indicated by red tag (8D). (Supply lines not included). Follow manufacturer’s

instructions when installing supply lines. Do not twist Supply Tubes (8A)!

7 FLUSH WATER LINES

A. Point lines into Bucket. TURN WATER BACK ON.

B. Flush the water lines. Allow water to run for at least 30 seconds. TURN WATER

BACK OFF BEFORE CONTINUING INSTALLATION.

9 DRAIN INSTALLATION

Install and adjust Drain (9A) using separate instructions supplied with the Drain assembly.

For T40-YP models, grid strainers must be ordered separately! For sinks with an

overow, order T47-9GS*. For sinks without an overow, order T47-7GL*.

10 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink.

COLD

HOT