User guide

ENGLISH

FAUCET INSTALLATION

Thank you for purchasing this Price Pﬁ ster product. All Price Pﬁ ster products are carefully engineered, and factory tested to

provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow

illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Price Pﬁ ster

recommends calling a professional if you are uncertain about installing this product!

This product should be installed in accordance with all local and state plumbing and

building codes.

NOTE: If installation surface depth is thicker than 1

”, order spare part

number 971-026.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually found

under the sink or near the water meter. If you are replacing an existing faucet, remove

the old faucet from the sink and clean the sink surface thoroughly.

3 TOOLS RECOMMENDED

• PTFE Plumber's Tape • Plumber's putty • Slotted screwdriver

• Phillips head screwdriver • Pliers • Adjustable wrench

• Flashlight • Cloth

Your installation may require new supply lines and / or shut-off valves or other additional

tools.

4 CHECKING THE CONTENTS OF THE BOX

Upon opening the box, check to ensure that all of the following items are included.

A Spout Body B Handles (2x) C Stem Extension (2x)

D Valve Bodies (2x) E Pop-Up Assembly F Pop-Up Rod

G Bag [Flange, Seal Base, Plastic Nut] (2x) H Hose

J Bag [Nuts (2x), Square Washer (2x)] K Hex Wrench

L Nut & Mounting Washer M Seal Base & Spout Base

If any of these items are missing, please contact Price Pﬁ ster Consumer Service at

1-800-Pfaucet (1-800-732-8238).

5 SPOUT ATTACHMENT

Insert Lift Rod (5A) into hole at the back of Spout (5B). Place Plastic Seal Base (5C)

against the bottom of Spout Base (5D). Place Spout Base (5D) against the bottom of

Spout Body (5E). With Spout (5F) facing forward, carefully install the Lift Rod (5A) and

Shank (5G) through the center hole of sink (5H).

6 SPOUT INSTALLATION

From underneath sink, secure Spout Body (6A) by placing Metal Washer (6B) and

threading Locknut (6C) onto Mounting Post (6D). Make sure that the bumps on Metal

Washer (6B) are facing up.

Caution: Do not over tighten!