User's Manual

Arming the Alarm/Locking the Doors
To lock the doors and arm the alarm, remove the ignition key,
shut both doors, and check that the tailgate is properly closed.
- Press once the raised logo button on the transmitter key.
- This command will be acknowledged by a single flash of the
hazard lamps.
- Both doors will be locked, the engine immobilised and the
alarm system armed. A settling period of 40 seconds must
expire before the ingress sensors become active.
- The alarm tell tale will flash once every 3 seconds.
- The interior and mood lamps (if lit) will fade off.
Note:
i) If the system is armed when a door is not fully shut, three
triple beeps will sound as a warning and the doors will not
be locked. Opening a door will not trigger the alarm.
ii) If the system is armed when the tailgate is not fully closed,
three warning
double beeps will be heard, and the doors will
not be locked. Opening a door in this instance will trigger the
alarm.
When fully armed, and after the settling period of 40 seconds
has expired, the alarm will be triggered by any of the following
actions:
- Interruption of the car battery power supply or siren cables.
- Energising the ignition circuit (‘hot wiring’).
- Opening a door;
- Opening the tailgate;
- Movement detected within the cabin (unless de-selected).
If the alarm is triggered, the hazard warning lamps will flash
and the wailing siren will sound for a period of approximately 30
seconds before closing down and resetting, ready for any further
triggering input. If a trigger is continuously present (e.g. door left
open), the alarm will repeat for a maximum of eight 30 second
cycles before excluding the triggering sensor for the remainder
of the armed period.
To silence the siren, press once the central, disarm button on
the transmitter key. If necessary, press a second time to disarm
the alarm. Note that if the vehicle battery has been disabled, it
will not be possible to interrupt the siren until completion of the
sequence.
Keys & Car Security Alarm
19