User Manual

IM_100.CCF.20170512-EN C45

Software Installation

4.3 Installation on MAC OS

1. Go to our webseite www.pilotfly.de or www.pilotfly.com.tw on to the support page.

2. Download the most current version of the SimpleBGC software there.

3. Download the most current version of the "CP2102 USBtoUART" driver there.

4. Ensure, that you have installed Java Run Time.

5. Install the driver CP2102 USBtoUART.

Tip

Function!

The software SimpleBGC of Basecam Electronics uses a

virtual COM interface. Thus, you must create lock file before, that the

software works under OSs. Proceed very attentively as follows for it

especially if you are less experienced:

 Start the terminal under „Utilities“:

 Create a folder „/var/lock“ with the following command:

sudo mkdir /var/lock

 Password-Request by MAC OS. Enter your Log-In password and confirm by pressing Enter.

 Change the release of the prepared folder with the following order:

sudo chmod 777

/var/lock

 Either allow your system to run non-signed applications by setting this in System

Preferences > Security & Privacy > General > Allow Applications downloaded from:

Anywhere; Or you can allow just this one app to run by answering Open when prompted

by the system dialog.

6. Extract the SimpleBGC Software

7. Enter the command "chmod+u+x" into the terminal followed by a blank (Space) and the path

to the file "stm32ld_mac" in the folder "bin" within the application folder (use drag&drop to

copy the entire path and to paste into the terminal). Confirm by pressing Enter to execute the

command.

8. Start the Software with SimpleBGC_GUI.jar

9. Selcet /dev/tty.SLAB_USBtoUART

In the connection drop down menue

and press Connect.