User Manual

IM_100.CCF.20170512-EN C45
38
Using the Software PC/MAC - ADVANCED
5.9 Extended settings for advanced users – View level
“ADVANCED”
Caution
Function
!
The software SimpleBGC offers further possibilities, which are
however not necessary for the use and the adjustment of the Pilotfly Gimbals.
Thus, these functions are not described within the context of this introduction
manual. For the use of this extended functionality we refer you to the software
user manual SimpleBGC 32bit 3-Axis. The performing of functions which aren't
described to your Pilotfly product within the context of this instruction manual
happens on your own responsibility. Pay attention to the safety hints.
This view level "ADVANCED" is suitable for advanced users. Here you have access to the features which
were already described under "BASIC" and additional possibilities for an even finer optimisation of your
Pilotfly Gimbal.
5.9.1 RC-Settings (Remote control, Joystick settings)
You will find the same settings as described at the basic settings  5.8.1 RC-Settings (Remote control,
Joystick settings) and additionally the following extended settings:
Input Configuration, Spektrum data and bind mode, Analog joystick auto-detection,
Mix signal from FC_ROLL, FC_PITCH inputs, PWM Bypass
5.9.2 Follow-Mode
You will find the same settings as described at the basic settings  5.8.2 Follow-Mode and additionally
the following extended settings:
Use Frame IMU, if possible, Apply offset correction when axis is not following, Follow rate inside
deadband, ROLL, PITCH, YAW Offset, ROLL, PITCH, YAW EXT.FC GAINS