User Manual

IM_100.CCF.20170512-EN C45

Using the Software PC/MAC - ADVANCED

5.9.3 Service (Assigning the Mode-button, Startup behavior)

You will find the same settings as described at the basic settings  5.8.3 Service and additionally the

following extended settings:

Working positions –

 Frame upside-down auto detection – if enabled, the controller detects startup in the

upsidedown mode: if you switch Gimbal ON when frame is turned over by ROLL axes, but

camera is not, - system enters upside-down mode automatically. If option is disabled, you have to

enter

this mode manually by the menu command.

 Briefcase mode auto- detection – it's useful in the “Follow” mode, when you turn frame by 90

degree over any axes, and do not want for camera to follow the frame. Converting to briefcase

position is very simple – just hold camera and rotate frame by 90 degree. Also, it will be

automatically detected at startup, if you have the “Follow” mode enabled by default.

 Upside-down PITCH auto-rotate – when the frame is turned upside-down over PITCH motor,

camera will be rotated by 180 degrees to track new position of the frame. Be sure that PITCH

angle is not limited in the RC tab, to allow camera to make this movement.

 Set to normal position on profile switch – normally, camera does not move when you switch to

a different profile, but keeps it position. You can enable this option in any profile, to move

camera to a neutral position, when switching to this profile.

Time-lapse-parameters –  5.14 Using time lapse settings - ADVANCED

 Time-lapse time, sec. – Enter here the duration for the movements in the timelapse function.

 Acceleration in and out time, % – Here you can set how fast the movements should be

accelerated or slow down when starting and stopping the movement.

 Frame angles are fixed – apply gyro drift correction –Enable the Drift-correction by marking

this ceck box.

Misc. settings –

 Emergency stop – enable this option to immediately stop motors if problems are detected, like

I2C-errors, over-temperature, short circuit, etc.

Restart system after a delay, ms – Enter the delay time until the system shall restart.

Buzzer and LED –  5.12 BUZZER and LED settings - ADVANCED

In this functional block you can activate the Beep tone for the given functions or deactivate it or

set its volume.

5.9.4 Firmware Upgrade

All settings are as described at  5.8.4 Firmware Upgrade. There are no extended options for advanced

users.