User Manual

IM_100.CCF.20170512-EN C45

Using the Software PC/MAC – Time lapse

5.11 Using the time lapse settings – ADVANCED

Your Pilotfly Gimbal supports a time lapse function. You should determine an end point and a starting point

for the scenes you wish to capture. The Gimbal then moves the camera at a speed set by you from the

starting position to the end point.

1. Select the register “service” and go to the

function block “Time lapse parameters”.

2. Enter the time period in seconds, in which

the camera should be moved from the

starting position to the end point into the

“Time lapse time,sec”.

3. You can also determine and select an

acceleration value in %, whether you would

like to use a gyro drift correction.

4. Save these settings individually for each as

a profile.

5. Stay in the “service” register, load this profile

and assign the mode button on your Gimbal,

for example as shown in the adjacent

illustration, pressing 5x “Setup and start

time-lapse motion”. Remark: We

recommend to assign this function with “5

clicks”, so that you have the profiles 1 to 4

for different settings of time-lapse time.

6. Press the “WRITE” button, to transfer the

settings to your Gimbal.