User Manual

IM_100.CCF.20170512-EN C45
58
Failure / Repair
Before you contact the service hotline Pilotfly-Service, please check by using the following table whether
you can solve the problem by yourself.
Warni
ng
Injury danger!
Do not carry out any repairs at the device by yourself.
Let the repairs at the device or at the cable only carried out by us
Pilotfly-Service. Extensive dangers for the user can arise from
improper repairs.
Roll motor is not horizontal levelled Please make a Gyro & ACC calibration described in the user
manual. Watch the video: https://youtu.be/IxpdtzvjzoQ
The system starts vibrating while
moving the Gimbal 90° forward
(brief case position)
Figure out which motor is causing the vibrations, in this case it is
most likely caused by the Pitch motor. If so decrease the D-
value of
the Pitch slightly or change Motor power value of Pitch.
Pitch motor is suddenly missing
steps while moving up or down.
Ensure proper balancing of the camera. Increase motor power
of Pitch motor.
System starts vibrating while
moving
Figure out which motor is causing the vibrations, and decrease the
D-value of the related axes or change Motor power value of related
axes.
System is slightly drifting on the
yaw axis.
Poor Gyro calibration of Frame IMU.
Frame IMU needs to be re-calibrated.
Note: Frame IMU must be calibrated via SimpleBGC Software
installed on your PC, MAC or Android App (SimpleBGC32)
While moving forward (brief case
position) roll ax
is keeps not straight
and is moving slightly to left or
right.
Poor ACC & Gyro calibration of Camera IMU. Please make a Gyro
& ACC calibration described in the user manual.
Watch the video: https://youtu.be/IxpdtzvjzoQ
Where can I find the serial number
of my Gimbal
You can see the serial number in the register "Firmware Upgrade"
of the SimpleBGC software.
The Gimbal
shows vibrations at the
preset
Vibrations can be eliminated with the help of the PID-parametres or
the filter setting in the SimpleBGC software.