User Manual

IM_100.CCF.20170512-EN C45

Failure / Repair

System is flattering in each

direction.

Wrong motor setup. Hold the Gimbal steady and start “Auto” for the

Motors in the Basic Tab of SimpleBGC GUI. Ensure that all motor

poles are set to “14”.

After that perform a calibration for Camera and Frame IMU sensors.

Video: https://youtu.be/IxpdtzvjzoQ

System starts beeping

continuously.

Check battery level. Battery might be exhausted. Charge battery or

connect the external battery.

System starts beeping and battery

is fully charged.

Check battery level in the SimpleBGC GUI on the right bottom

corner.

Battery calibration might be necessary. Please follow the instruction

for battery calibration.

Roll and pitch not in level even

after ACC & Gyro calibration

Verify in the RC –Tab of the SimpleBGC GUI the “Initial angle” of

each axes. Initial angle need to be set to “0”.

Note: Operations like “Set tilt angles by hands”, “Swap RC Roll-

Yaw” or “Swap RC Pitch – Roll” will save their angles to this field,

too.

The Gimbal cannot be connected

over Bluetooth with the SimpleBGC

32 bit Software GUI

Set the the View level on "ADVANCED". Now you will find the

option "Configure bluetooth" at the board settings .

There you can see the Bluetooth settings for the Bluetooth module.

The preset command is "AT". Press the button "SEND". If the

answer is OK / OK the cause of the error is not with the Gimbal, but

in all probability with the transmitter. Check possible errors with the

help of the transmitter-sided instructions for use.

The yaw-axis isn’t centered at the

start position

Perform an OFFSET-calibration. Center the yaw-axis manually or

by means of the joystick. Set the view level to “EXPERT”. In the

Watch the video:

https://www.youtube.com/watch?list=PL5lnuIIn_ZKcWR_SpY-

QbBoMWPPuOcXLk&v=XSjvjdD6cto