Instruction Manual

B)Sticky Mount
1. Find a flat, smooth and safe *surface
2. Wipe the surface clean
3. Remove the clip and replace the standing mount into the product.
4. Peel off the protective layer of the sticker
5. Stick the mount onto the surface.
1.
選擇平滑安全
*
的表面。
2.
把表面抹乾淨
3.
取下固定夾，然後將固定支架放回產品中。
4.
剝下貼紙的保護層。
5.
將支架黏貼到表面上选择平滑安全的表面。
*DO NOT install the car mount over an air bag cover of within the airbag deployment zone
*
不要將無缘汽車充電器安装在氣囊蓋上或安全氣展開區域内。
C) Charge your Oi-enabled device/
為您的
Q
設備充電
1. Wipe the mounting surface clean.
2. Paste the PU iron sheet on the central area of the mounting surface.*
1.
把表面抹乾净。
2.
將
PU
皮質鐵片貼在中心區域
*
。
*It is recommended to paste the PU iron sheet on the outer area of a lightweight protective case.
*
建议贴在轻薄保护壳的外面
Product Using Guideline:
1. This product is suitable to use when in car, home and office.
2. Can connect the product with car, car charger or homethrough the standard 2A current data cable.
(Because this product supports fast charge function, we recommended the mobile or tablet must have
and support QC3.0).
3. Put the phone or tablet on the silicone suction area of this product. (Pay attention that suck on the
center position of the product, make the phone or tablet that without any gap and fully press on the
suction.) Hold on 1 second and confirm that the product to be charged and has been firmly sucked on
the wireless charger before leaving hand.
产品使用说明:
1.本产品适用范围为车载,家居,办公室.
2.用标准要求可以通过 2A 电流的线，将产品连接到汽车的车载手机充电器或者家用的手。机充电
器,(因本产品支持快充功能,建议购买手机充电器时必须支持 QC3.0).