User Guide

Chapter 1: Welcome to Band-in-a-Box!
19
The choices are:
- General MIDI 2 support: If you're using the Roland VSC3, or a newer Sound Canvas (i.e. newer than
1999, or newer than the Roland SC88), then choose this GM2 support.
- Roland GS (older Modules): “Older” Sound Canvases (SC55/SC88) support GS, but not GM2. The good
news is that they have the same patches available, just at different locations. So if you choose this option,
Band-in-a-Box will find the patches at the “GS” locations instead of the “GM2” locations. If you have a
newer GS module like the SC8820, it supports both GM2 and GS - you should likely choose GM2.
- No GM2 support: Some sound cards don't have GM2 support but they do support the original 128
General MIDI sounds. Band-in-a-Box will use the closest instrument in these cases.
Audio Setup
The [Audio Settings] button in the MIDI/Audio Drivers Setup displays the
current audio driver and status, MME/ASIO/ASIO Always On. Band-in-a-Box performs the audio setup
automatically using the installed system audio components
To restore or modify this set up click on the Preferences button and then select the
[Audio] button to launch the Audio Settings dialog.
To reset the default MME driver settings click on [Get from soundcard…] and
Band-in-a-Box will analyze the sound card and enter the correct audio settings.
If your computer has ASIO capability you can use these drivers instead of the default MME drivers.
ASIO Audio/Software Synth Drivers
By using an ASIO audio driver, software synths like the Roland VSC (DXi or VSC) will play with almost no
latency (delay is only 5-10ms). So you’ll hear the sounds instantly, and be able to play along using MIDI Thru with
the same ultra-low latency.