User Guide

Chapter 6: Band-in-a-Box PowerGuide
128
You can enable/disable the audio reverb. If you disable it, this will save
some CPU cycles, so this might be advisable on an older/slower machine if you hear that
the audio is clicking or not keeping up.
Click on the green Select a Preset button to open the list of presets. This list will
show only the “Band-in-a-Box Default Reverb” until you save some presets of your own.
As you adjust the settings, they will be applied to the current song. The [Swap
“Default”] button toggles between your current settings and the default settings. This
allows you to hear the effect of the changes you make to the settings.
Use the row of “room” buttons to load typical settings for different types of spaces.
These buttons are a convenient way either to apply a particular effect or to load settings
that you can then tweak to make your own preset.
Reverb Parameters
Pre-Delay is the time delay of first reflections.
Decay is the time it takes for reverb to decay. Reverb time is measured as RT60, the time
it takes for reverb to decay to a level -60 dB below the dry signal level.