User Guide

Chapter 13: Tools and Utilities
366
Adjusting Reverb Reduction
Experiment to get a feel for what works. There may be some songs where the reverb can't be improved, and in those
cases just disable the Reduce Reverb Checkbox.
Some vocals have short pre-delay and reverb tails. Short attack and release would make sense.
Some songs (especially ballads) have loud “balloon” reverb tails with long pre-delay. Since the reverb comes in
after the vocal phrase begins, and lasts a long time after the vocal phrase ends, longer attack and release would make
sense. Adjust the Attack so that the compression kicks in about the same time as the pre-delay reverb, and adjust the
release long enough to hold back the reverb after a vocal line is finished.
Don't expect miracles. You can reduce the reverb level, but will rarely completely eliminate vocal reverb.
Judiciously use just enough compression to avoid ruining the overall fidelity.
Compare the dry sound against the processed sound. The maximum vocal reduction setting could be extreme
enough to ruin the instrumental quality. Sometimes it is better to allow some vocal leakage to achieve the best-
sounding instrumental quality. Is it better to allow some low voice leakage to improve the bass response? Is it
better to allow some high voice leakage to improve the cymbals and acoustic guitar?
After the PG Vocal Remover is adjusted as good as it gets, try inserting an Equalizer plug-in downstream. Notch
some frequencies to improve the effect.
If the output amplitude is inconsistent, try inserting a compressor or peak limiter plug-in downstream.