Legacy Owner's Manual

14
4. Reinstall burner and light as normal and inspect flame. If
burner requires additional adjustment repeat above procedure.
There is not a significant degree of adjustment required to these
burners.
Differences in altitude, operating conditions, weather conditions;
gas pressures, odorants and stabilizers used in both natural gas
and propane will often cause burners to burn differently. As
long as you are getting good ignition, even cooking performance
and the burner flame is blue with yellow tips and operating
consistently, you should not have to adjust the burners.
YELLOW TIPPING
Properly adjusted burner
NORMAL HARD FLAMES
Slightly out of adjustment burner
YELLOW FLAMES
Extremely out of adjustment burner
GRILL COVER
WE STRONGLY RECOMMEND COVERING YOUR PGS GAS GRILL WHEN
NOT IN USE. YOU MAY PURCHASE A COVER DESIGNED TO FIT YOUR
GRILL FROM YOUR PGS DEALER.
REPLACEMENT PARTS
USE ONLY PGS ORIGINAL REPLACEMENT PARTS AVAILABLE THROUGH
YOUR DEALER OR CONTACT AEI CORPORATION FOR CLOSEST PARTS
SUPPLIER.
T SERIES GRILLS FROM PGS
PGS is proud to offer a full series of grills equipped with one-hour gas
timers built right into the controls. This insures that the gas flow to the
grill stops at one hour or less. This prevents wasting a precious
resource, prevents damage done if grills are left on for hours (or days)
at a time, and provides peace of mind so you don’t have to worry “did I
leave the grill on?” Below is an image of our S27T on a stainless-steel
pedestal.
PGS offers LEGACY series grills with a built-in PGS Fuel-Stop
ONE HOUR FLOW timer that will automatically shut the gas
flow supply off at a maximum of one hour. The TIMER grills (T
Series) were specifically designed for added safety, convenience
and energy saving for home owners and commercial users alike.
To operate the PGS Fuel-Stop, One Hour Flow timer, simply turn
the timer knob clockwise to at least 30 minutes, then back to
desired gas flow time. When time selected is reached, gas flow
to control valves stops. If additional time is desired, turn all gas
control valves to OFF position, turn PGS Fuel-Stop timer past 30