TEATRO V-3.0 AND PC-3.
TEATRO V-3.0 AND PC 3.0 FLAT PANEL L-C-R SOUND BAR SPEAKER Thank you for purchasing the Phase Technology TEATRO LCR high definition flat panel sound bar speaker system. The TEATRO sound bar speaker’s Left-Center Right configuration with Phase Technology’s Enhanced Voice Technology, EVT™ center channel design and our Spatial Field Expander, SFE™ enable the speaker to provide outstanding dialogue clarity for movies with an open wide sound stage normally obtained only with separate component speaker systems.
FLAT PANEL WALL MOUNT ATTACHMENT INSERTS 8 3/16” USE THESE SETS OF HOLES FOR SPEAKER BRACKETS FOR NORMAL WALL MOUNTING CENTER INPUT LEFT INPUT RIGHT INPUT FIGURE 1 least 2 holes on each bracket that line up over a wall stud. Drill the wall and install your anchors and fasten the brackets to the wall with the “J” bend at the bottom (fig. 2 & 3). Step 3 Place your TEATRO sound bar speaker face down on a soft clean surface with the grille on.
Adjust the rubber stand-off bumpers by turning them either in or out to adjust the tilt of the speaker until the front is vertical. Lock the adjusting screws in place by tightening the locking nuts against the rear of the cabinet. Please be certain that the nylon washer is between the nut and the cabinet to protect the cabinet finish. Step 6 Since the TEATRO sound bar speakers form the front 3 speakers in a home theater system for flat panel displays they are to be used and set up as you would any normal 5.