Manual

Introduction
The Pro Series 1000 backup sump
pump system is battery-operated. It is
designed as an emergency backup
system to support your regular AC sump
pump, and it will automatically begin
pumping if your main AC pump fails.
Should any malfunction or emergency
occur that involves the sump pump, the
battery, or the AC power, your Pro
Series 1000 battery backup sump pump
system will sound an alarm and indicate
the nature of the problem and the
solutions by means of a lighted display
on the control panel.
The Pro Series 1000 Battery Backup
Sump Pump System includes:
1 Control unit with a float switch and a
battery fluid level sensor
1 Pump with 1
1
⁄2" PVC pipe adapter
1 Battery box with safety strap
2 Plastic wire ties for mounting the
control unit and the float switch
1 Battery cap with a hole to
accommodate the fluid sensor
1 Battery charger
You will also need to supply:
 A Pro Series 1000 Standby Battery
(A maintenance-free battery is not
recommended)
 1
1
⁄2" PVC pipe and fittings
 PVC cement and primer
 A rubber union with hose clamps
or a "Y" connector and two (2)
check valves depending on the
installation method you use
 Six (6) quarts of 1.265 specific
gravity battery acid
For narrow sump pits you will need
some additional parts:
 An "L" bracket at least 6 inches
long. (Preferably one that will not
rust.)
 Two (2) stainless steel hose
clamps
 One (1) stainless steel screw
(#8-32 x
3
⁄4"), a matching washer
& nut
Page 2
CONTROL UNIT
BATTERY
BOX
CAP
WIRE TIES
FLOAT
SWITCH
PIPE
ADAPTER
PUMP
CHARGER
FLUID
SENSOR
BATTERY CABLES