Instructions / Assembly

Operation Instructions
19
CONNECTING THE LP TANK
NOTE:
Other cylinders may be acceptable for use with this appliance if they are compatible
with the appliance nesting hole and retention means. Refer to Page 19 of the Assembly
Instructions for correct cylinder to cylinder holder connection.
WARNING:
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO PREVENT
FIRE, DAMAGE AND/OR INJURY.
1. The knob on the LP tank must be closed. Make sure that the knob is
turned clockwise to a full stop. The cylinder supply system must
be arranged for vapor withdrawal.
2. Check that the control knob on the control unit is turned off.
3. Remove the protective cap from the LP tank valve and coupling nut.
4. Hold the regulator in one hand and insert the nipple into the valve
outlet. Be sure the nipple is centered in the valve outlet. The coupling
nut connects to the large outside threads on the valve outlet. Use care
do not cross thread the connection.
5. Hand-tighten the coupling nut clockwise until it comes to a full
stop. Firmly tighten by hand only. Do not use tools.
To Disconnect: Fully close the tank valve by turning clockwise.
Turn the coupling nut counterclockwise until the regulator assembly detaches.
Installation mode of the gas cylinder
WARNING:
In the connection process, make sure:
• The regulator inlet connector mates with the cylinder valve out let properly,safely and rmly.
• The LP gas hose does not come in contact or remain in contact with the rebox.
ENJOY YOUR CAPTIVA DESIGNS