Instructions / Assembly

First-time Operation

Prior to using your Captiva Designs gas grill, verify that all of the following is true:

• The burner tube is free of any debris or obstruction.

• The proper gas type, gas connection, and regulator settings have been installed.

• You’ve checked for gas leaks.

• Minimum clearances listed on certiﬁcation tag are maintained.

• All packaging has been removed.

• All parts and components are properly in place.

• An installer-supplied manual gas shutoff valve is fully accessible.

• Always inspect the gas supply metal hose before every use. If the metal hose shows any signs of abrasions

or cuts, DO NOT use the grill. The metal hose must be replaced before using again.

• The pressure regulator and metal hose assembly supplied with this grill must be used. Any requirement for a

replacement regulator and metal hose assembly must be made through the manufacturer.

Lighting the Appliance

1. Read instructions before lighting.

2. Open lid during lighting.

3. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the lighting

procedure.

Manually Lighting the Burners

1. Open the lid,make sure the control knob is in the "Off" position.

2. If you have just attempted to light the burner, allow 5 minutes for any accumulated gas to dissipate.

Use caution by standing as far away from the burners as possible. Do not put your hands, arms, head, or

any other body parts close to the grill when lighting.

3. Push in and turn the control knob to Max.

4. If the burner does not light after 5 seconds, turn the control knobs to the OFF position.

5. Wait 5 minutes until the gas clears before attempting to light again.

6. If the burner does not light after several attempts, immediately close all gas valves and consult an

authorized service technician.

WARNING:

“Flash-back” may occur in or around the burner tubes. This event exhibits a characteristic “whooshing”

or jet-like sound. If this occurs, immediately turn off your burners, then remove and clean them with soap,

water and a brush until all foreign objects are removed.

Before cooking with your appliance for the ﬁrst time, burn off any foreign matter and rid the unit of any odors

by running the main burners on Max for about 10 minutes. Similarly, you should always preheat the grill before

cooking by turning the burners to Max for 5 minutes .

ENJOY YOUR CAPTIVA DESIGNS