Instructions / Assembly

First-time Operation

Prior to using your Captiva Designs gas grill, verify that all of the following is true:

• The burner tube is free of any debris or obstruction.

• The proper gas type, gas connection, and regulator settings have been installed.

• You’ve checked for gas leaks.

• Minimum clearances listed on certication tag are maintained.

• All packaging has been removed.

• All parts and components are properly in place.

• An installer-supplied manual gas shutoff valve is fully accessible.

• Always inspect the gas supply metal hose before every use. If the metal hose shows any signs of abrasions

or cuts, DO NOT use the grill. The metal hose must be replaced before using again.

• The pressure regulator and metal hose assembly supplied with this grill must be used. Any requirement for a

replacement regulator and metal hose assembly must be made through the manufacturer.

Lighting the Appliance

1. Read instructions before lighting.

2. Open lid during lighting.

3. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat thelighting

procedure.

Manually Lighting the Main Burners

WARNING:

Do not use standard-size matches or cigarette lighters to perform match-lighting procedures. Serious

burns can occur, and lighters can explode.

1. Open the hood.

2. If you have just attempted to light the burner, allow 5 minutes for any accumulated gas to dissipate.

Use caution by standing as far away from the burners as possible. Do not put your hands, arms, head, or

any other body parts close to the grill when lighting.

3. When match-lighting the grill, use the lighting wand provided with your Captiva Designs grill (see below).

ENJOY YOUR CAPTIVA DESIGNS