User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Operation Mode Introduction
- Chapter 3: Hardware Installation
- Chapter 4: Software Configuration
- Chapter5: PoE (Power over Ethernet)
- Chapter6: Specification
- Appendix A: Troubleshooting
- Appendix B: Certification
- Appendix C: Glossary
150Mbps Wireless N Access Point
www.phicomm.com
22
Chapter 4: Software Configuration
Note: If you have no idea about the wireless network, security mode or encryption type please
login to the configuration page of your main AP/Router to check the information.
Wireless Security Settings
Wireless Network Name (SSID): Show the current wireless network name.
Security Mode:
You can choose Disable, Open, Shared, WEPAUTO, WPA-Personal, WPA2-Personal, WPA-
Personal/ WPA2-Personal.
Mode 1: Security Mode > Disable
If you do not want to use wireless security, highlight on this option. That means other people
can connect to your wireless network without entering any password, so it may slow down your
internet speed, it’s recommended strongly to choose one of the following modes to enable
security.
Mode 2: Security Mode > Open/Shared/ WEPAUTO
Open System: Select 802.11 Open System authentications.
Shared Key: Select 802.11 Shared Key authentications.
WEPAUTO: Select Shared Key or Open System authentication type automatically based on the