User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Operation Mode Introduction
- Chapter 3: Hardware Installation
- Chapter 4: Software Configuration
- Chapter5: PoE (Power over Ethernet)
- Chapter6: Specification
- Appendix A: Troubleshooting
- Appendix B: Certification
- Appendix C: Glossary
150Mbps Wireless N Access Point
www.phicomm.com
26
Chapter 4: Software Configuration
TX Power: Wireless transmission power. You can choose from 1 to 100.
Short Preamble: Leave it as enable.
Pkt_Aggregate: Leave it as disable.
DFS RD Region: Choose the region for the wireless network.
Enable WMM: If you select it, the router will process the packets with the priority first. You are
recommended to select this option.
APSD Capable: It is used for auto power-saved service. It is Disabled by default.
Multicast-to-Unicast: Leave it as enable.
Wireless Clients List
You can check the wireless clients of the access point in this page.
WPS Settings
The WPS function can help you add a new device to the network quickly. If the client device
supports Wi-Fi Protected Setup and is equipped with a WPS button, you can add it to the
network by pressing the WPS button on the device and then press the button on the router