User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Operation Mode Introduction
- Chapter 3: Hardware Installation
- Chapter 4: Software Configuration
- Chapter5: PoE (Power over Ethernet)
- Chapter6: Specification
- Appendix A: Troubleshooting
- Appendix B: Certification
- Appendix C: Glossary
150Mbps Wireless N Access Point
www.phicomm.com
29
Chapter 4: Software Configuration
Refresh: Click Refresh button to refresh the DHCP clients list.
System Tools
There are seven submenus under the System Tools: Factory Defaults, Backup and Restore,
Password, System Log, Traffic Statistics, Firmware Upgrade and Reboot. Click any of them,
and you will be able to configure the corresponding function.
Factory Defaults
Click Restore All Settings button to reset all configuration settings to their default values.
Note: All changed settings will be lost when defaults are restored.
Backup and Restore
In the Export Settings column, click Backup button to save all configuration settings to your
local computer as a file.
To restore the Router's configuration, follow these instructions:
1) Click Browse button to find the configuration file which you want to restore.