User's Manual

150Mbps Wireless N ADSL2/2+ Modem Router
www.phicomm.com
5
Chapter 2: Hardware Installation
Interface/Button Indication
DSL Connect to the Modem port of splitter or directly to the wall jack
LAN (1-4) Connect to your network devices
RST Restore to factory default settings by pressing and holding for 5 seconds
WPS Used to create a secured wireless network quickly by pressing the WPS button
PWR Connect with a power adapter
ON/OFF Turn on/off the power of Modem Router
Physical Connection
Before installing the device, please make sure your broadband service provided by your ISP is
available. If there is any problem, please contact your ISP. You need to connect the device to the
phone jack, the power outlet, and your computer or network. Before cable connection, turn off
the power supply and keep your hands dry. You can follow the steps below to install it.
Step 1: Connect the ADSL Line.
Method one: Plug one end of the twisted-pair ADSL cable into the DSL port on the rear panel of
FD-364N, and insert the other end into the wall socket.
Method two: You can use a separate splitter. External splitter can divide digital data and voice,
and then you can access internet and make calls at the same time. The external splitter has three
ports:
• LINE: Connect to the wall jack.
• PHONE: Connect to the phone sets.
• MODEM: Connect to the DSL port of FD-364N. Plug one end of the twisted-pair ADSL line into
the DSL port on the rear panel of FD-364N. Connect the other end to the MODEM port of the
external splitter.