User's Manual

150Mbps Wireless N ADSL2/2+ Modem Router
www.phicomm.com
6
Chapter 2: Hardware Installation
Step 2: Connect the Ethernet cable. Attach one end of a network cable to your computer’s
Ethernet port or a regular hub/switch port, and the other end to the LAN port on the FD-364N.
Step 3: Attach the power adapter. Connect the AC power adapter to the PWR connector on the
rear of the device and plug in the adapter to a wall outlet or power extension.
Step 4: Turn on your computers and power on the Modem Router.
Note:
• If you currently use a modem, disconnect it now. The Modem Router will replace your old
modem.
• After the physical connection, please check whether the LEDs of the Wireless Modem Router
display normally as the diagram below describes.