User's Manual

150Mbps Wireless N ADSL2/2+ Modem Router
www.phicomm.com
21
Chapter 4: Software Configuration
3. PPPoA/PPPoE
Select this option if you have a username and password to access internet. This option is
typically used for DSL services. Select Dynamic to obtain an IP address automatically for your
PPP connection. Select Static to use a static IP address for your PPP connection. Please enter the
information accordingly.
Username: Enter your username for your PPPoA/PPPoE connection.
Password: Enter your password for your PPPoA/PPPoE connection.
Encapsulation: For both PPPoA/PPPoE connection, you need to specify the type of Multiplexing,
either LLC or VC -Mux.
Bridge Interface: Activate the option, the Wireless Modem Router can also work in Bridge
mode.
Connection Setting: For PPPoA/PPPoE connection, you can select Always on or Connect
on-Demand or Connect Manually. Connect on demand is dependent on the traffic. If there is no
traffic (or Idle) for a pre-specified period of time), the connection will tear down automatically.
And once there is traffic sending or receiving, the connection will be automatically on.
TCP MSS Option: Enter the TCP MSS as you desire.
Default Route: You should select Yes to configure the PVC as the default gateway to internet.