User's Manual

150Mbps Wireless N ADSL2/2+ Modem Router
www.phicomm.com
23
Chapter 4: Software Configuration
LAN
Router Local IP: These are the IP settings of the LAN interface for the device. These settings may
be referred to as private settings. You may change the LAN IP address if necessary. The LAN IP
address is private to your internal network and cannot be seen over internet.
IP Address: Enter the Router’s local IP Address, then you can access to the Web based Setup
Wizard via the IP Address, the default value is 192.168.1.1.
IP Subnet Mask: Enter the Wireless Modem Router’s Subnet Mask, the default value is
255.255.255.0.
Second IP Address: Show another LAN IP address that you can use to login to the Wireless
Modem Router.
Second IP Subnet Mask: The default value is 255.255.255.0, you do not need to change it if
unnecessary.
IGMP Snoop: Active the IGMP Snoop function if you need.
Dynamic Route: Select this option to specify the RIP (Routing Information protocol) version for
LAN interface, including RIP1, RIP2-B and RIP2-M. RIP2-B and RIP2-M are both sent in RIP2 format,
the difference is that RIP2-M using Multicast, while RIP2-B using Broadcast format.