User's Manual

150Mbps Wireless N ADSL2/2+ Modem Router
www.phicomm.com
27
Chapter 4: Software Configuration
SSID: Refer to your wireless network name, you can change it to anything you want. The SSID
must be identical for all devices in the wireless network. It is case-sensitive and must not exceed
32 characters. Make sure this setting is the same for all stations in your wireless network. Type
the desired SSID in the space provided.
Broadcast SSID: When wireless clients survey the local area for wireless networks to associate
with, they will detect the SSID broadcast by the Wireless Modem Router. To broadcast the
Router’s SSID, keep the default setting. If you don’t want to broadcast the Router’s SSID, select
Disabled.
Use WPS: It allows you to add a new wireless device to an existing network quickly by pushing
WPS button if your wireless adapter also supports Wi-Fi Protected Setup.
WPS Settings: These are the settings of WPS. It shows only when this function is enabled. In this
condition, you can just leave the Authentication Type as OPEN.
WPS state: Show the configuration states of WPS function.
WPS mode: You can set the WPS either via pressing the WPS button or enter the PIN number
manually.
1. PIN code
Please write down the PIN code of your wireless network adapter and enter it into the bar of
enrollee PIN code.
Then push the WPS button on your adapter. The WPS light will first get flashing then solid on if
the operation succeeds.
2. PBC
First, push the button of WPS on this Wireless Modem Router, release it. Then turn to your
wireless network adapter, push the WPS button and release it. Wait a moment, the WPS will
become flashing then finally get solid on if the connection is successful.