Operation Manual

150Mbps Wireless N Access Point
www.phicomm.com
17
Chapter 4: Software Configuration
Running Status
Running Status page shows the current status of the wireless access point.
Wireless Basic Settings
a) AP Mode
By default, the operation mode is AP.
Operation Mode: It displays the current operation mode. Choose the operation mode in the
drop-down list, the corresponding configuration page will pop up.
Note: Since the DHCP server of your original router is enabled and it assigns IP addresses to you
computers automatically so you have to disable the DHCP service on the wireless Access Point
after the settings.
Wireless Status: Choose Enable to enable the wireless function, choose Disable to disable the