Operation Manual

150Mbps Wireless N Access Point
www.phicomm.com
21
Chapter 4: Software Configuration
Channel Bandwidth: The bandwidth of the wireless channel, you can select 20MHz or
20/40MHz.
Wireless Access Node Mac Address: The following operations are the same as setting it as
Bridge. Click Search then the Site Survey page pops up. Choose the wireless network which
you’d like to bridge, then click Connect.
e) Repeater Mode
SSID1: If you configured it as a repeater successfully, the SSID1 would be the same with your
main AP/Router.
Wireless Mode: If all of the wireless devices connected with this wireless router are in the same
transmission mode (e.g. 802.11b), you can choose "Only" mode (e.g. 11b only). If you have some
devices which use a different transmission mode, choose the appropriate "Mixed" mode.
Channel: If you configured it as a repeater successfully, the channel would be the same with
your main AP/Router.
Channel Bandwidth: The bandwidth of the wireless channel, you can select 20MHz or
20/40MHz.
SSID: Click Search, the Site Survey page will pop up, please connect to the wireless network
name of your main AP/Router.
MAC Address: The Mac Address will be automatically put in after the above operations.
Channel: The channel will pop up automatically. It is the same as the wireless channel of your
main AP/Router.
Security Mode/Encryption Type: Choose the security mode and encryption type according to
the wireless network you’d like to connect, and enter the password.