Operation Manual

150Mbps Wireless N Access Point
www.phicomm.com
33
Chapter 5: PoE (Power over Ethernet)
Chapter5: PoE (Power over Ethernet)
Equipped with Power Injector, the Access Point can be placed at any position regardless of the
location of the Power Adapter (within a certain distance range).
Hardware Overview of PoE
DC: Connect to the provided power adapter.
PoE: Connect to the LAN port of AP.
LAN: Connect to the Ethernet device with CAT5 Ethernet cable to transmit data.
Installation with PoE Injector
1. Turn off all your network devices, including the Switch, power injector and the AP.
2. Connect your Modem Router to the LAN port on the power injector with an Ethernet cable.
3. Plug the provided power adapter into the DC jack on the power injector, and the other end to
a standard electrical wall socket.
4. Connect your AP to the PoE (LAN) port on the power injector with an Ethernet cable.
Note: Provided with the power of DC 5V/1A, the cable between PoE port of passive PoE Injector
and the LAN port on Access Point is not more than 30m long, and all cables connected to the
passive PoE Injector should be no more than 100m long.