Operation Manual

300Mbps Wireless N Router
www.phicomm.com
28
Chapter 3: Router Configuration
Open Port Protocol: The protocol used for Incoming Ports Range, it can be TCP, UDP or
TCP/UDP. If you are not clear about which protocol was being used, TCP/UDP is recommended.
Note:
• Before using Port Triggering, you should assign a static IP address to the designated server,
and then enter this static IP address into router as the Server IP Address.
• Please ensure the SPI Firewall was closed before setting the port triggering. You could check
the SPI Firewall settings at Security Options>Security Settings.
DMZ Host
DMZ Status: Choose Enable DMZ.
IP Address of the DMZ Host: Enter the IP address of the computer in the LAN that you want to
set to a DMZ host in the DMZ Host IP Address field.
Note:
• Before using DMZ Host, you should assign a static IP address to the designated server, and
then enter this static IP address into router as the Server IP Address.
• DMZ priority is higher than the Port Forwarding, if the DMZ open, all the port forwarding
rules are not effective.
UPnP
UPnP: Click the checkbox to Enable or Disable the UPnP.
Save: Click Save button to save your setting.