Operation Manual

300Mbps Wireless N Router
www.phicomm.com
34
Chapter 3: Router Configuration
Gateway: This is the IP address of the default gateway device that allows for the contact
between the Router and the network or host.
Dynamic Routing Settings
RIP: The Routing Information Protocol (RIP) is a dynamic routing protocol used in local and wide
area networks. Choose Enable dynamic routing need to be activated.
Rip Version: Choose the version of RIP.
Authentication Code: Choose the encrypt method used between routers.
IP Bandwidth Control
Enable IP bandwidth control: If you select it, the bandwidth control rule takes effect.
Total Uplink Bandwidth: The rate of uploading through the WAN interface.
Total Downlink Bandwidth: The rate of downloading through the WAN interface.
Note:
• The bandwidth conversion: 1 Mbps = 1024 Kbps.
• Select the type of the broadband line and the bandwidth according to the actual situation.
If you are not sure about the information, consult your broadband provider.
• After finishing the settings, click the Save button to apply the settings.