Operation Manual

300Mbps Wireless N Router
www.phicomm.com
30
Chapter 3: Router Configuration
PIN: If this option is enabled, you need to enter a wireless clients PIN code in the blank and keep
the same code in the client.
WDS Settings
The WDS function can help you extend the wireless range, it supports Bridge Mode and
Repeater Mode.
Bridge Mode: You can wirelessly connect two or more wired networks via this mode. In this
mode, you need to add the wireless MAC address of the connecting device into the Routers AP
MAC address table or select one from the scanning table. At the same time, the connecting
device should be in Lazy, Repeater or Bridge mode.
Repeater Mode: You can select the mode to extend the distance between the two WLAN
devices. Functioning as a WDS repeater, the connects to both a client card as an AP and to
another AP. In typical repeater applications, APs connecting to other APs equipped with WDS
functionality must also support WDS. In this mode, you need to add the MAC address of the
connecting device into the Routers AP MAC address table and the connecting client should be in
Lazy, Repeater or client mode.