User's Manual

2
300Mbps Wireless N Rouer
Chapter 1: Introduction
LED Status Description
Power
On Power is on
Off Power is off
WLAN
On Wireless network is switched on
Off Wireless LAN is disabled
Blink Data is transmitting
WPS
Off WPS function is disabled
Blink
A wireless device is connecting to the network by WPS function. This
process will last in the first 2 minutes
On
A wireless device has been successfully connected to the network by
WPS function
WAN
On Internet is connected
Off Internet is unconnected
Blink Data is transmitting
LAN (Port 1-4)
On LAN port is connected
Off LAN port is unconnected
Blink Data is transmitting
Rear Panel
Long press and hold the button for 8 seconds, the Router will reboot to
its factory default settings.
Reset
Press the button and the WPS LED in front panel flashing, WPS function is
enabled.
WPS
Using Ethernet cables, these Ethernet ports (4, 3, 2, 1) connect the Router
to computers and other Ethernet network devices on your wired network.
LAN (1-4)
The Power port connects to the included power adapter.
Power
The power on/off but ton.
ON/OFF
Using an Ethernet cable (also called a network or Internet cable), the
Internet port connects the Router to your Internet connection, which is
typically a cable or Digital Subscriber Line (DSL) modem.
WAN