User's Manual
Table Of Contents
- _
-  Introduction
-  Installation
-  Router Configuration
-  Specification
-  Appendix A: Troubleshooting
-  Appendix B: CE Mark Warning
-  Appendix C: Glossary
-  Appendix D: Technical Support
9
Chapter 2: Installation
300Mbps Wireless N Rouer
4. You are prompted to select your WAN interface t ype, there are three t ypes available: DHCP,
Static IP and PPPoE.
a. Select Dynamic IP (DHCP) if your ISP does not give you any IP numbers to use.
This option is commonly used for cable modem services. Router will obtain IP address
information automatically. In this case, no need to input anything but click Next.
b. Select Static IP if all the internet ports IP information is provided to you by your ISP, you
will need to enter in the IP address, subnet mask, gateway address and DNS address, and
then click Next.
c. PPPoE is t ypically used for DSL services. Select PPPoE and fill the Username and Password
information provided by your ISP, and then click Next.