User's Manual

22
Chapter 3: Router Configuration
300Mbps Wireless N Rouer
WDS Mode: In this mode, you can expand the scope of network by combining up to four
other access points together, and every access point can still accept wireless clients.
Bridge Mode: You can wirelessly connect t wo or more wired networks via this mode. In
this mode, you need to add the Wireless MAC address of the connecting device into the
Routers AP MAC address table or select one from the scanning table. At the same time,
the connecting device should be in Lazy, Repeater or Bridge mode.
Repeater Mode: You can select the mode to extend the distance bet ween the t wo
WLAN devices. Functioning as a WDS repeater, the W306R connects to both a client card
as an AP and to another AP. In typical repeater applications, APs connecting to other APs
equipped with WDS functionality must also support WDS. In this mode, you need to add
the MAC address of the connecting device into the Routers AP MAC address table and the
connecting client should be in Lazy, Repeater or client mode.
Encryption Type: You can select WEP 64bits mode, WEP 128bits mode TKIP mode, AES
mode for securit y here.
Encryption key: Enter the key, the key format according to encryption you selected.
Wireless Access Node MAC Address: Input the MAC address of another wireless
router.
Note: Two wireless routers must use the same band, channel number, and security