User's Manual
Table Of Contents
- _
-  Introduction
-  Installation
-  Router Configuration
-  Specification
-  Appendix A: Troubleshooting
-  Appendix B: CE Mark Warning
-  Appendix C: Glossary
-  Appendix D: Technical Support
26
Chapter 3: Router Configuration
300Mbps Wireless N Rouer
Application Name: Describe the name of the application that being set.
Start/End Trigger Port: The port for outgoing traffic. An outgoing connection using this
port will trigger this rule.
Trigger Protocol: The protocol used for Trigger Ports, TCP, UDP, or TCP/UDP. If you are
not clear about which protocol was being used, TCP/UDP is recommended.
Open Port: The port or port range used by the remote system when it responds to the
outgoing request. A response using one of these ports will be forwarded to the PC that
triggered this rule.
Open Port Protocol: The protocol used for Incoming Ports Range, either TCP or UDP,
or TCP/UDP. If you are not clear about which protocol was being used, TCP/UDP is
recommended.
To modify an existing entry:
Enable: Select the number of application and click the Enable button to make it
enabled.
Disable: Select the number of application and click the Disabled button to make it
disabled.
Delete: Select the number of application and click the Delete but ton.
Reset: Select the number of application and click the Reset button.
To add a new rule, follow the steps below:
Click Increase the application of rules button, the following screen appear: