User's Manual
Table Of Contents
- _
-  Introduction
-  Installation
-  Router Configuration
-  Specification
-  Appendix A: Troubleshooting
-  Appendix B: CE Mark Warning
-  Appendix C: Glossary
-  Appendix D: Technical Support
33
Chapter 3: Router Configuration
300Mbps Wireless N Rouer
IP Bandwidth Control
There are t wo submenus under the IP Bandwidth Control menu. Click any of them, and you
will be able to configure the corresponding function.
•
IP Bandwidth Control Settings
Enable IP bandwidth control: If you select it, the bandwidth control rule takes effect.
Total Uplink Bandwidth: The rate of uploading through the WAN interface.
Total Downlink Bandwidth: The rate of downloading through the WAN interface.
Save: Click the Save button to save your set ting.
Note:
•
The bandwidth conversion: 1 Mbps = 1024 Kbps.
•
Select the t ype of the broadband line and the bandwidth according to the actual
situation. If you are not sure about the information, consult your broadband provider.
•
After finishing the settings, click the Save button to apply the set tings.
•
IP Bandwidth Control List
Enable IP bandwidth control: If you select it, the bandwidth control rule takes effect.
Total Uplink Bandwidth: The rate of uploading through the WAN interface.
Total Downlink Bandwidth: The rate of downloading through the WAN interface.
Bandwidth setting: The min. rate can be zero, the sum of all items min. rate should be