User's Manual

2
300Mbps Wireless N Rouer
Chapter 1: Introduction
the Router sends or receives data over the wireless network.
Wi-Fi Protected Setup (WPS) LED: If you have client devices, such as wireless adapters,
that support Wi-Fi Protected Setup, then you can use the Wi-Fi Protected Setup button to
automatically configure wireless securit y for your wireless network. To use Wi-Fi Protected
Setup, refer to the section of Wi-Fi Protected Setup.
WAN: The Internet LED lights up when there is a connection made through the Internet port. It
flashes to indicate network activity over the Internet port.
LED (1-4): These LEDs are corresponding with the LAN ports on the rear panel. The LED is
continuously lit when the Router is connected to a device through that port. It flashes to
indicate network activity over that port.
LED Status Description
Power
On Power is on
Off Power is off
WLAN
On Wireless network is switched on
Off Wireless LAN is disabled
Blink Data is transmitting
WPS
Off WPS function is disabled
Blink
A wireless device is connecting to the network by WPS function. This
process will last in the first 2 minutes
On
A wireless device has been successfully connected to the network by
WPS function
WAN
On Internet is connected
Off Internet is unconnected
Blink Data is transmitting
LAN (Port 1-4)
On LAN port is connected
Off LAN port is unconnected
Blink Data is transmitting