User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Router Configuration
- Chapter 4: Download Wizard
- Chapter 5: Specification
- Appendix A: Troubleshooting
- Appendix B: Certification
- Appendix C: Glossary
300Mbps Wireless N NAS Rout
www.phicomm.com
39
Chapter 3: Router Configuration
Open Port: The port or port range used by the remote system when it responds to the
outgoing request. A response using one of these ports will be forwarded to the PC that
triggered this rule.
Open Port Protocol: The protocol used for Incoming Ports Range, it can be TCP, UDP or
TCP/UDP. If you are not clear about which protocol was being used, TCP/UDP is
recommended.
Note:
• Before using Port Triggering, you should assign a static IP address to the designated
server, and then enter this static IP address into router as the Server IP Address.
• Please ensure the SPI Firewall was closed before setting the port triggering. You could
check the SPI Firewall settings at Security Options>Security Settings.
DMZ Host
Choose Enable DMZ.
IP Address of the DMZ Host: Enter the IP address of the computer in the LAN that you
want to set to a DMZ host in the DMZ Host IP Address field.