User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Router Configuration
- Chapter 4: Download Wizard
- Chapter 5: Specification
- Appendix A: Troubleshooting
- Appendix B: Certification
- Appendix C: Glossary
300Mbps Wireless N NAS Rout
www.phicomm.com
46
Chapter 3: Router Configuration
MAC/IP/Port Filter
This page is used to enable the firewall filtering function, select the filtering service or
manually set the parameters that need to be filtered, such as MAC address, IP address and
Port. You must set at least one filtering condition. You may also set multiple conditions or
all the conditions.
MAC/IP/Port Filter: Select Enabled or Disabled to enable or disable filtering.
Default Policy：Accepted chose, all the packets and devices will be allowed to be passed
normally, opposite action will be happened if Dropped was been chosen.
Current IP/Port Filtering Rules: All the existing rules will be listed below, any needed of
rules deleting, please select the rules, and then click Delete Selected.