User's Manual

150Mbps Wireless N Router
www.phicomm.com
16
Chapter 3: Router Configuration
WAN
WAN Connection Type: To make sure the connection type your ISP provides, please refer to the
ISP for more information.
Dynamic IP (DHCP): Connections use dynamic IP address assignment, it means your ISP is
running a DHCP server.
Static IP: Connections use static IP address assignment, it means your ISP provides a static or
fixed IP Address, Subnet Mask, Gateway and DNS setting.
PPPoE: Connections requires username and password.
L2TP: Layer 2 Tunneling Protocol (L2TP) is a service applies to connections in Israel only.
PPTP: Point-to-Point Tunneling Protocol (PPTP) is a service applies to connections in Europe only.
Select the connection type according to the information provided by your Internet Service
Provider (ISP), and fill in the information accordingly.
MTU Size (in bytes): The default MTU (Maximum Transmission Unit) value is 1500 Bytes.
Sometimes you need to modify the MTU required by your ISP.
Please check Manually configure the DNS server if your ISP gives you one or two DNS IP
addresses. Otherwise, leave it unchecked, the DNS servers will be assigned from ISP dynamically.
Primary DNS Server: Enter the DNS IP address in dotted-decimal notation provided by you r ISP.
Secondary DNS Server: Enter another DNS IP address in dotted-decimal notation provided by
your ISP.
Note: If you get Address not found error when you access a website, it is likely that your DNS
servers are set up improperly. You should contact your ISP for correct DNS server addresses.