User's Manual

150Mbps Wireless N Router
www.phicomm.com
21
Chapter 3: Router Configuration
You can allow/deny the computers connecting to the router wirelessly by entering the MAC
address with this feature.
If you only want MAC address (00:0A:EB:00:07:5F) to access the Wireless Network while others
cannot:
1: Choose Allow for the security policy.
2: Fill MAC address 00:0A:EB:00:07:5F in and click Save.
If you want MAC address (00:0A:EB:00:07:5F) cannot access the Wireless Network while others
can:
1: Choose Reject for the security policy.
2: Filling MAC address 00:0A:EB:00:07:5F in and click Save.
Advanced Wireless Settings
This section is to configure the advanced wireless setting of the Router, if you are not familiar
with the setting items in this page, it’s strongly recommended to keep the provided default
values, otherwise it may result in lower wireless network performance.
Beacon Interval: The interval for sending packets of the Beacon frame. Its value range is
20-1000 in unit of ms. The default is 100.
DTIM Interval: It indicates the interval of the delivery traffic indication message (DTIM). The
value range is between 1 and 255 milliseconds. The default value is 1.
Fragment Threshold: Set the fragmentation threshold. Packets larger than the size set in this
field will be fragmented. Too many data packets will lower the Wireless Network performance.
The Fragment Threshold value should not be set too low. The default value is 2346.
RTS Threshold: Set the RTS (Request to send threshold.) threshold. When the packet size is
larger than the preset RTS size, the wireless router will send a RTS to the destination station to
start a negotiation. The default value is 2347.