User's Manual

35
Chapter 4: Router Configuration
Wireless Nano Router
www.phicomm.com
will trigger this rule.
Trigger Protocol: The protocol used for Trigger Ports: TCP, UDP or TCP/UDP. If you are not clear
about which protocol was being used, TCP/UDP is recommended.
Open Port: The port or port range used by the remote system when it responds to the outgoing
request. A response using one of these ports will be forwarded to the PC that triggered this rule.
Open Port Protocol: The protocol used for Incoming Ports Range, it can be TCP, UDP or
TCP/UDP. If you are not clear about which protocol was being used, TCP/UDP is recommended.
Note: Before using Port Triggering, please assign a static IP address to the designated server, and
then enter this static IP address into router as the IP Address.
DMZ Host
DMZ Status: Choose Enabled or Disabled to enable or disable this function.
IP Address of the DMZ Host: Enter the IP address of the computer in the LAN that you want to
set to a DMZ host in the DMZ Host IP Address field.
Note:
• Before using DMZ Host, you should assign a static IP address to the designated server, and
then enter this static IP address into router as the IP Address.
• DMZ priority is higher than the Port Forwarding, if the DMZ open, all the port forwarding
rules are not effective.
UPnP
UPnP Status: Select Enabled or Disabled to enable or disable this function.